Yoder Smokers Pellet Grill Thermocouple
| Beschikbaarheid: | Op voorraad (1) |
| Levertijd: | De levertijd bedraagt 1 á 2 werkdagen. |
YS480
- Serial numbers after 74001
- You will need the PT-1000 probe
- Please verify here: Temp Probe Verification
- Serial numbers before 74001 and ACS (Wifi) controllers
- You will need the Short J-type probe
- If you have upgraded or replaced your controller you may need the PT-1000 probe
- You can verify here: Temp Probe Verification
- If no probe type is visible in the settings, make sure you are connected to Wifi and allow the firmware to update to the latest version
- If updating the firmware is not an option for you, you can assume that your version requires the Short J-type probe
- Legacy (non-Wifi) controllers with firmware R37 and newer
- You will need the Short J-type probe
- Legacy (non-Wifi) controllers with firmware older than R37
- You will need the Long J-type probe
YS640
- Serial numbers after 74001
- You will need the PT-1000 probe
- Please verify here: Temp Probe Verification
- Serial numbers before 74001 and ACS (Wifi) controllers
- You will need the Short J-type probe
- If you have upgraded or replaced your controller you may need the PT-1000 probe
- You can verify here: Temp Probe Verification
- If no probe type is visible in the settings, make sure you are connected to Wifi and allow the firmware to update to the latest version
- If updating the firmware is not an option for you, you can assume that your version requires the Short J-type probe
- Legacy (non-Wifi) controllers with firmware U29 and newer
- You will need the Short J-type probe
- Legacy (non-Wifi) controllers with firmware older than U29
- You will need the Long J-type probe
YS1500
- Serial numbers after 74001
- You will need the PT-1000 probe
- Please verify here: Temp Probe Verification
- Serial numbers before 74001 and ACS (Wifi) controllers
- You will need the Short J-type probe
- If you have upgraded or replaced your controller you may need the PT-1000 probe
- You can verify here: Temp Probe Verification
- If no probe type is visible in the settings, make sure you are connected to Wifi and allow the firmware to update to the latest version
- If updating the firmware is not an option for you, you can assume that your version requires the Short J-type probe
- Legacy (non-Wifi) controllers
- You will need the Short J-type probe